[DonC]

I don't have wifi in my practice room so I don't update that often, but recently got 3.8.35.

In general it works, loading the data base seems to be faster, but the page display is slower than the previous version I had which was about 6 months old.
I can see that each page is set up in two separate steps, first showing the PDF and then adding the annotations to that.
In the previous version it was instantaneous.
Unfortunately I have found 2 real problems.
1) I sometimes have pages that are black with just the annotations.  This appears to be related to how fast after opening a piece I try to change the page.  I presume that I am changing pages before all the pdf is read and it is for some reason not loaded correctly.  The bad pages have always been the bottom half of page 2 or 3.
2) Custom stamp symbols are clipped to one side.  In the pop-up bubble they are shown correctly, when on the page they are cropped to one side.  I can send you photos by email if you would like to see that more.

Running Win 10 Pro 22H2 with all updates.

Best, Don