12-01-2024, 06:22 PM
loopMIDI works just fine on Windows 11. LoopBe1 should accomplish the same goal though.
I'll run through my own test and hopefully it will be helpful for you:
1) I opened loopMIDI
2) I went to Settings->MIDI Settings->Configure MIDI Connections and checked both the input and output ports for loopMIDI (the output port just shows up as "MIDI")
3) I opened Gig Performer, went to Options->MIDI Ports and verified that it was connected to the input and output ports for loopMIDI
4) I clicked the Setlists section, right-clicked the Verse for Song 1, clicked Song Part Properties, click Edit for the MIDI messages, changed the MIDI Message type to Control Change, and set the CC # to 9 and the CC Value to 5 (these are just dummy values)
5) I right-clicked a song in MobileSheets, went to the MIDI tab, tapped the + icon, set it to "Control Change" entered 10 for the number and 5 for the value, and enabled "Load Song on Receive".
6) I tapped OK, tapped OK to save the changes, and then clicked the song section in the setlist in GP. The song is then loaded in MobileSheets
That is just one example of something you can do. You can also go to Settings->MIDI Settings, enable "Allow Page Control with Pitch Bend", and then send "Pitch Bend" messages from Gig Performer to control page changes in MobileSheets. The pitch bend value you send determines what page is switched to in MobileSheets. So that's another way to handle it. It all just depends on what your goal is.
Mike
I'll run through my own test and hopefully it will be helpful for you:
1) I opened loopMIDI
2) I went to Settings->MIDI Settings->Configure MIDI Connections and checked both the input and output ports for loopMIDI (the output port just shows up as "MIDI")
3) I opened Gig Performer, went to Options->MIDI Ports and verified that it was connected to the input and output ports for loopMIDI
4) I clicked the Setlists section, right-clicked the Verse for Song 1, clicked Song Part Properties, click Edit for the MIDI messages, changed the MIDI Message type to Control Change, and set the CC # to 9 and the CC Value to 5 (these are just dummy values)
5) I right-clicked a song in MobileSheets, went to the MIDI tab, tapped the + icon, set it to "Control Change" entered 10 for the number and 5 for the value, and enabled "Load Song on Receive".
6) I tapped OK, tapped OK to save the changes, and then clicked the song section in the setlist in GP. The song is then loaded in MobileSheets
That is just one example of something you can do. You can also go to Settings->MIDI Settings, enable "Allow Page Control with Pitch Bend", and then send "Pitch Bend" messages from Gig Performer to control page changes in MobileSheets. The pitch bend value you send determines what page is switched to in MobileSheets. So that's another way to handle it. It all just depends on what your goal is.
Mike