9 hours ago
The only time that would happen is if you have the page scaling set to "Fullscreen". You should never see it shift otherwise.
As far as your question, no, that's not really possible, because the nudge tool only operates on what has been selected, and a stamp is not automatically selected just by you creating it. I don't support a selection state with most tools, as it would interfere with other parts of the logic in the code. I generally only allow things to be selected when using the stamp tool. You can enable the option to automatically select stamps after they are created though, which would then let you immediately nudge them into place if needed. You'd then just need to switch back to the stamp tool to place the next stamp (which you can do with a two finger tap).
Mike
As far as your question, no, that's not really possible, because the nudge tool only operates on what has been selected, and a stamp is not automatically selected just by you creating it. I don't support a selection state with most tools, as it would interfere with other parts of the logic in the code. I generally only allow things to be selected when using the stamp tool. You can enable the option to automatically select stamps after they are created though, which would then let you immediately nudge them into place if needed. You'd then just need to switch back to the stamp tool to place the next stamp (which you can do with a two finger tap).
Mike