05-01-2015, 02:34 AM
- drill a hole in the music stand -
... perfect, brilliant.
The only suggestion I'd add, FWIW, would be to clamp a little spring clamp on either side of the tablet to restrain side-to-side movement (in case the stand is bumped, etc etc). The goal being to minimize side forces on that plug going into the headset jack, cuz those jacks are typically a weak point/failure point in phones + tablets. They're mostly soldered right into the motherboard inside, and those solder joints and the board itself tend to crack over time, with anything but the most gentle handling.
... perfect, brilliant.
The only suggestion I'd add, FWIW, would be to clamp a little spring clamp on either side of the tablet to restrain side-to-side movement (in case the stand is bumped, etc etc). The goal being to minimize side forces on that plug going into the headset jack, cuz those jacks are typically a weak point/failure point in phones + tablets. They're mostly soldered right into the motherboard inside, and those solder joints and the board itself tend to crack over time, with anything but the most gentle handling.