• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Creating network for tablets to join for Master/Slave
#9
MR3020
(You might want to reset the device before doing anything in case there is some problem with it...)
I set it to 3G in the switches at the side. I connected power and ethernet to my MacBook.
Once into admin settings, I went to wireless settings and put in the SSID (save) and a password for wireless security. Save, reboot.
For some reason the tablets now connect switched to 3G (instead of WISP which used to work) although it might be because I have updated my firmware just now. Again, I tested with iPads sorry, but it worked with page turns once I connected.
I will see if I can set up an MS setup to test.


If it works well at home then as Mike says, it might be signal quality at the gig location. You might like to try other locations away from interference to determine if this is a problem. Or one of the tablets is misbehaving with its wifi. Have you another tablet to try with (replacing one at a time to see if there is a problem)?
Reply


Messages In This Thread
RE: Creating network for tablets to join for Master/Slave - by bumblebee - 12-10-2017, 05:02 PM

Digg   Delicious   Reddit   Facebook   Twitter   StumbleUpon  


Users browsing this thread:
1 Guest(s)


  Theme © 2014 iAndrew  
Powered By MyBB, © 2002-2022 MyBB Group.