• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Strich BT-FP2 (Boston version)
#1
Lightbulb 
This pedal funcions and is used both with Samsung TAB-a and MS Surface Book.
Only a question:
When the footswich is not operated over a certain (short) time the unit goes in sleep-mode.
When a new command has to be send, the footswitch has to be operated two times. The fist to re-activate and the second time to send the command.

Is there a possibility to overcome the switching to the sleep-mode?

I use the pedalfunction scrol up/down for scrolling, and the padalfunction page up/down for scrolling down and jump to next link When programmed. Manual selection on the footswich is no problem for me.
Spelerke Erik
Using Samsung Tab-s with Android 7.1.1
Thumbs up for this application! Smile
Reply
#2
Timing out and going to sleep is the biggest nuisance of a number of pedals. It was one of the reasons for me to trade in the FireFly for an AirTurn. However, the BT-FP2 should be based on the Coda BT2, and this pedal has a timeout of 25 minutes which should be acceptable.
So the answer lies in the documentation, and if neccessary contact Strich support.
Johan
www.johanvromans.nlwww.hetgeluidvanseptember.nlwww.howsagoin.nl
Samsung Galaxy Note S4 (T830) 10.5", Android 10.0, AirTurn Duo & Digit.
Samsung A3 (A320FL), Android 8.0.0 (emergency).
Reply


Digg   Delicious   Reddit   Facebook   Twitter   StumbleUpon  


Users browsing this thread:
1 Guest(s)


  Theme © 2014 iAndrew  
Powered By MyBB, © 2002-2021 MyBB Group.