[jeffn1]

Thanks, Graeme:

Re: No - both way too small for a 13" tablet.

But I would be placing the tablet in in portrait mode. So, if the top is open it only has to be wide enough to fit the width of the tablet in portrait mode.

You might be right. I can check the dimensions. (The Hanspree 13 is wider in portrait mode than the Toshiba 13).

Thanks, Grame, i will look further into this. I appreciate everyone's thoughts (any additional ideas/suggestions are welcome).

Happy New Year!

Jeff

Thanks, Kav. What type of aluminum is that? Where would I get something like that?

Looks like ordinary flat strip. You should be able to find something at your local DIY supplier. Failing that, a metal stockist.

It might not work for me, in part, because I would like a stand that I could use for either the Toshiba Excite 13 or the Hannspree 13.

If you check the dimensions of both units, they'll almost certainly be very similar. I think that either would fit into this holder.

I wonder if either of these would work:

No - both way too small for a 13" tablet.