• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
new firmware - Airturn Duo BT200
#1
My airturn duo BT200 had been working a treat until I updated the firmware (v2.2.0).  After some fiddling I have got it turning pages on my android phone, however still nothing on windows 10.  Is this likely a MS issue or Airturn?  It pairs successfully to both windows, and MS airturn direct, however no response from pedals or buttons.  I would happily return it to factory default firmware, however I can't figure out how to do that either.  Any help would be much appreciated!
Reply
#2
Does this help?
https://desk.zoho.com/portal/onsong/kb/a...e-1-5-2019
Johan
www.johanvromans.nlwww.howsagoin.nlwww.hetgeluidvanseptember.nl
Samsung Galaxy Note S4 (T830) 10.5", Android 9.0, AirTurn Duo & Digit.
Samsung Galaxy Note 2 (N8010) 10.1", Android 7.1.2 (LineageOS) (backup).
Samsung A3 (A320FL), Android 8.0 (emergency).
Reply
#3
(08-06-2019, 04:20 PM)sciurius Wrote: Does this help?
https://desk.zoho.com/portal/onsong/kb/a...e-1-5-2019
Sadly no.  I have tried resetting multiple times, and connecting in every different mode, but nothing yet!  I have just noticed that the unit is only blinking every 3 seconds which is meant to mean it's paired to a device, but the only two devices I have paired it to are turned off, and I have reset the airturn multiple times with no change in blinking pattern!  Seems like I should contact airturn support, as it doesn't seem to be a problem with MS airturn direct code.
Reply
#4
You probably tried this, but did remove airturn as a recognized device on your tablet and then try to re-pair it?
Reply


Digg   Delicious   Reddit   Facebook   Twitter   StumbleUpon  


Users browsing this thread:
1 Guest(s)


  Theme © 2014 iAndrew  
Powered By MyBB, © 2002-2019 MyBB Group.