[domgi]

I can look into that if it's necessary. Is there a reason you couldn't just zoom in with whatever display mode is active though? Is there a reason you would need to switch modes?

Thanks,
Mike

Yes there is a reason, I will explain this very common situation:
1. When i read and play: "normal" full dual page view
2. When we stop playing to write annotations:
a) i need to enter edit mode (either by triple tapping the concerned page when it works, but there is often a 2-3 seconds delay, or single tapping the screen to show overlay mode THEN choose annotation mode witch is a safer way, advance to the next page when it is the right side one)
b) pinch zooming and grabbing in the music to the desired spot
c) select desired tool and write it (often with pen, marker or stamp, select and eraser tools when needed)
d) save to exit and return to normal view, change page when needed to repeat or go to other pages to copy annotations)

Alternate trick: when i know we are going to stop often in the same music spot, i can change normal view mode to full widht screen half pages to avoid the zooming/grabbing procedure and just enter/exit annotation mode after editing the music, but the line size needs to be pumped up about +2 points to match full page mode. The problem with this trick is if the conductor decides to go on reading further because my half pages turning points are not set yet, so i need to switch viewing mode again while playing!

I could setup a second BT pedal if i could program some of those mode switching, tool selectig or even save/exit actions to foot control and free up/reduce finger interraction for writing exclusively.