[Rey_a]

Diesem Artikel kannte ich schon. Danach habe ich den T5 und MSP  eingerichtet. Es hat nur leider nicht geklappt. 

Gatzi,

I cannot remember whether  the 'usb to host' connector on tyros is considered to be USB 1 or USB 2. 
The setup in my old post/article will only work if it is considered to be USB 2

You can check which one it is, by going to the MIDI settings and then the RECEIVE tab (see image attached) and then loading a sheet in MSP that is configured according to the post. You should see a small light popping up in either the PORT 1 or PRT 2 line at the bottom of the screen when the MIDI commands are received.

If it is in PORT 1, you will need to change the first line (port 1 CH1) of the midi receive settings onTyros and replace 'Song' in the column 'part' by keyboard. Then save that MIDI configuration to disk.
If I remember everything correctly, the setup as described in my old post should then work.

Good luck

Rudy