[Spelerke]

This pedal funcions and is used both with Samsung TAB-a and MS Surface Book.
Only a question:
When the footswich is not operated over a certain (short) time the unit goes in sleep-mode.
When a new command has to be send, the footswitch has to be operated two times. The fist to re-activate and the second time to send the command.

Is there a possibility to overcome the switching to the sleep-mode?

I use the pedalfunction scrol up/down for scrolling, and the padalfunction page up/down for scrolling down and jump to next link When programmed. Manual selection on the footswich is no problem for me.

[sciurius]

Timing out and going to sleep is the biggest nuisance of a number of pedals. It was one of the reasons for me to trade in the FireFly for an AirTurn. However, the BT-FP2 should be based on the Coda BT2, and this pedal has a timeout of 25 minutes which should be acceptable.
So the answer lies in the documentation, and if neccessary contact Strich support.